It is a Nakajima A6M2-N 2 floatplane fighter of 1/144 scale. Sweet has obtained a new report of the U.S. military investigation, and it is a definite version kit that accurately reproduces the dimensions of the unknown point.
The dolly (ground-moving carriage) and wave scene base are attached, and you can choose either of the display positions.
For some reason, I finished painting the water decoration table first. I might do the white dry brush a bit more. I plan to paint the fighters as belonging to track island and Maikor Island in Indonesia, so I made a shade like an emerald green that imaged the south island. I blew blue and green based on Mr. crystal’s color, tourmaline green. It is a surprisingly good transparent feeling. I purchased crystal colors a few years ago but had no opportunity to use them in my modeling.
Paint the engines.
Masking of a cockpit and concentration are required for fine work. Especially the Japanese airplane in WWII with many frames. I used a Tamiya masking tape that also adapts to the curved surface.
I completed the basic painting with dark green and light gray-green. Although it is still plain, after putting the decal, it should make it look better dramatically.
(16-June-2017)
Nakajima A6M2-N is completed. It is a water plane based on Zero. Because it is splashed from the propeller at boarding time, the pilot gets on and off the starboard. By the way, Sweet’s box character also hangs on the right-side ladder.
The total amount of production is 327 aircraft. It was especially mass-produced as a water fighter. At that time, only Japan was developing watercraft with human resources.
The marking is 902nd Flying Group Fighter Squadron, Caroline Is. Truk I. Oct. 1943-Feb.1944.
I painted the engine and applied the dry brush to look slightly visible.
Dolly and water base and Nakajima A6M2-N.
The lower side of the aircraft was light gray-green, and the No.3 air-to-air bomb was painted a silver line. It would be easy if Sweet made the silver line decals, but is it too difficult to paste the tiny seal?
The antenna wire is a fine metal wire. To be sure, I thought about strength and wrapped it around the rod. There seems to be no thread break.
This fighter’s lightning mark is added, and the propeller spinner is red. Both fighters’ propeller fronts are painted in silver, but the backside is matte black. The reason is not to be disadvantageous to the pilot by a shiny reflection.
The marking is 934th Flying Group Fighter Squadron, Banda Sea Ambon / Enu Is. Maikoor Indonesia, Mar.1943-Feb.1944.
At first, I thought this water base was unnecessary and Didn’t put extra stuff in it. But it is recommended because this base is painted and decorated with a good appearance.
The mold of the panel line was so delicate that it was impossible to put much effective inking. I was worried about how to complete this fighter.
Mini-scale airplanes are small and look easy to finish, but it’s not easy. As the adhesive protrudes, it gets dirty immediately, and fine masking is complex. It is small enough to put on my palm. Interestingly, the sense of precision is tremendous.
I bought this kit a couple of years ago; compared with the price range of the previous 1/144 kit, even if it entered two aircraft, it was expensive at a price. Of course, there are no complaints about details and molds.
(20-June-2017)
